Chad

You people are so clueless. RTM = Release to Manufacturers I am subscribed to MSDN and it is OFFICIAL RELEASE! Get with the program blind mice!

I did not setup port forwarding incorrectly unless your blind It works fine for DC++, just not in APEX DC++ In APEX, I can't use manual port forwarding, can't use passive, can't use anything! Why does it work in DC++ then? I'm using official Vista RTM Limewire, DC++ both work but not APEX I can grab the public list and connect, but I cannot get file lists nor search results I do not have software firewall installed, I have Avast Antivirus installed only. I tried 192.168.2.1 for "network interface for all connections" What should go in TLS?

I know that. That IP shown is my IP address, still does not work

I can't get this going at all. Impossible I have setup everything as should and I get no search results at all See attached. What to do? I have a Belkin Pre-N router and Optimum Online ISP DC++ works fine, why not APEX?

I already have port 2020 forwarded in my router and it works fine for DC++ but not for Apex DC++ I set it to 2020 in Apex and input 192.168.2.2 in BIND address, I pressed "get actual IP" and put 2020 in tcp/udp ports, tls left 0. I checked, it still fails on TDP. This is odd and stupid. BIND address is not in DC++ as well, not sure why its in APEX

Trying to use active connection , same way I did with DC++ but it fails on TCP, UDP is ok. I tried various TCP ports, including same one DC++ was using (and DC++ is closed at time of testing) Wireless LAN adapter Wireless Network Connection 2: Connection-specific DNS Suffix . : Belkin IPv4 Address. . . . . . . . . . . : 192.168.2.2 Subnet Mask . . . . . . . . . . . : 255.255.255.0 Default Gateway . . . . . . . . . : 192.168.2.1 I input my actual IP address starting with 24. and not sure what to input in Network Address for All Connections

It was the small toolbar option. I fixed that, but now using Apex theme and RadoX-ApexDC toolbar, each icon is showing the next icon's function. Example: sounds shows "check for updates" and check for updates icon is missing

See attached. Why is this happening? I'm using PeerWeb 0.41