allshe

[1.0.1][Bug] no memorize column settings?

13 posts in this topic

if I set column what I want and then when I turn off apex and back turn on, column has default settings (breadth and order)

:)

(sorry for my English)

Share this post


Link to post
Share on other sites

Set the column width and order, then reopen the hub tab, settings will be saved (RTFM, it is mine). :)

Share this post


Link to post
Share on other sites

Set the column width and order, then reopen the hub tab, settings will be saved (RTFM, it is mine). :)

No, they are not saved; I want this order for hubs:

Nick, Shared, Exact Share, Slots, Connection, Hubs, Description, IP.

What I get (no matter what I do) is:

Nick, Shared, Exact Share, Connection, Description, IP, Hubs, Slots.

Similarly in search windows: the columns won't save in my preferred order.

Using 1.01

Share this post


Link to post
Share on other sites

Set the column width and order, then reopen the hub tab, settings will be saved (RTFM, it is mine). :)

No, they are not saved !!!

Share this post


Link to post
Share on other sites

Umm, saving might have been broken in 1.0.1... Haven't tested it, don't ask ME why. :)

Share this post


Link to post
Share on other sites

Umm, saving might have been broken in 1.0.1... Haven't tested it, don't ask ME why. :)

1.0.1 has been out for two days... not sure why you haven't tried it yet. :(

Share this post


Link to post
Share on other sites

Well, i'm not a beta tester, but it's so easy to check...

Using apex 1.0.1 built from source.

I swap some tabs, then closed apex. Then opened it again. The tabs order is saved. I tried it three or four times in different ways -- everything is OK. So if there any bug, it lies deeper than the surface...

I recommend two things:

1) ensure that you're using *LAST* version of apex.

2) try to *delete* all settings, leave bare .exe and run it again (and then check behavior) -- maybe you put your new .exe into your beta5's folder (i noticed some strange effects including share flushing, maybe this is the next one...)

Sorry if any flood :)

Share this post


Link to post
Share on other sites

I verify this bug. When i change the order/width of the columns so are they always back 2 default the next time i start Apex :rolleyes:

Share this post


Link to post
Share on other sites

Hi

I'm not sure whether someone has already reported this bug, but here it goes.

After updating to v1.0.1 I noticed that in connected Hub window

the userlist column settings are lost during restart of the ApexDC++.

In v1.0.0.B5 this behavior was not present.

Also when I updated from v1.0.0.B5 some settings where lost.

For example: Shared Directories.

Best Regards

Prtj

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.